Parker HannifinP Series User Guide 1330x2209 - Digital Input Signal 10 Selection UINT RW No -0x220A - Digital Input Signal 11 Selection UINT RW No -0x220B - Digital Input Signal 12 Selection UINT RW No -0x220C - Digital Input Signal 13 Selection UINT RW No -0x220D - Digital Input Signal 14 Selection UINT RW No -0x220E - Digital Input Signal 15 Selection UINT RW No -0x220F - Digital Input Signal 16 Selection UINT RW No -0x2312 - Multi-Step Operation Speed 1 INT RW No -0x2313 - Multi-Step Operation Speed 2 INT RW No -0x2314 - Multi-Step Operation Speed 3 INT RW No -0x2315 - Multi-Step Operation Speed 4 INT RW No -0x2316 - Multi-Step Operation Speed 5 INT RW No -0x2317 - Multi-Step Operation Speed 6 INT RW No -0x2318 - Multi-Step Operation Speed 7 INT RW No -0x2319 - Multi-Step Operation Speed 8 INT RW No -0x231A - Velocity Command Switch Select UINT RW No -0x2227 - Analog Velocity Command FilterTime Constant UINT RW No -0x2229 - Analog Velocity Command Scale INT RW No -0x222A - Analog Velocity Command ClampLevel UINT RW No -Table 75. Related Objects for Velocity Control6.4.2 Function Set of Velocity Command SwitchAnalog speed command when the contact is on after setting the value, 1 or 2.Ex 1) Set value is 2 and, Input Analog command 10[V] in the state that SPD1 and SPD2are on.Operating motor speed is 100[rpm] and not available analog input commandspeed.Operating speed is operated by multistep command speed in the set value ofparameter 0x2315.Ex 2) Set value is 2 and, Input Analog command 10[V] in the state that SPD1, SPD2 andSPD3 are on.Operating motor speed is 1000[rpm] and not available digital input commandspeed.Operating speed is operated by analog speed command voltage in the set value ofparameter 0x2229.Set Value Setting Details0 Use Analog speed command1 Use input contact SPD1, SPD2 and Analog command speed.2 Use input contact SPD1, SPD2, SPD3 and Analog speed command3 Use input contact SPD1, SPD2, SPD3 Speedwww.comoso.com
