8-26 Frame Relay Module 4.0 User Guide, Rev 012 = Alternate Route on Line Busy – selects the first port that has LCNs available(is not busy). If the port has failed, the next available port will be selected.3 = Least LCN with Throughput – selects the line with the minumum loading, cal-culated by weight and number of LCNs in use on that line. (Each line is assigneda weight proportional to its throughput within the routing path.)If use of a routing algorithm is not desired, simply accept the default, and specify onlyone routing path.Systematic Redirectionwill redirect (if Y) all calls to Redirection Address 0 instead of the primary address. Ifthat address cannot be reached and Redirect on Busy and/or Redirect on Out of Orderare set to Y, a call will be placed to Redirection Address 1, then (if necessary) Redi-rection Address 2, and so on.Redirect on Busywill redirect calls (if Y) according to the Redirection Addresses if the current sub-scriber has no LCNs available.Redirect on Out of Orderwill redirects calls (if Y) according to the Redirection Addresses if the if the currentsubscriber’s port is out of order.Connection Priorityprioritizes this subscriber for intra-nodal traffic; the higher the number, the higher thepriority. (This priority has no effect on traffic exiting a node.)Priorities are configured on all logical interfaces that use a physical frame relay port.The device processor in the node uses these priorities to help determine the order inwhich it will process protocols.When configuring priorities, be careful to consider the types oftraffic being routed on other connections in the node.1st,2nd,etc. Path Configuredincludes or excludes the associated port as a routing path to the subscriber device. Atleast one path must be specified.RLPidentifies the RLP that contains the port specified for the next parameter.Portidentifies the port(s) that make up the routing path(s).Redirection Address 0,1,etc.are up to five subscribers that will be called according to the specified redirectionoption. The FRM can redirect an X.25 call to an alternate subscriber if the originalsubscriber cannot be reached. (See "Redirect on Busy" and "Redirect on Out of Order.")The FRM will call each address in the list until one is reached. If Systematic Redi-rection is enabled, the FRM will not call the original called subscriber, but will startimmediately with the first subscriber in the redirection list.
