Introduction to System Operation 17-3C Restore the Backed-Up Database to a Remote FRX4000 – is not used on theFRM.D Back up the Current Database to a Local DirectoryE Restore the Database from a Local DirectoryF Back Up the Current System Files to a Local DirectoryG Restore the System Files from a Local DirectoryD Test X.25 Address Translation Templates – (Chapter 8) Tests templates toassure they were correctly created.E Re-Load Initialization to Async Console – (Chapter 18) Sends default terminalsettings to an Auxiliary Console on the node's COM1 port.F IP Ping Connectivity Test – (Chapter 18) Uses the Ping function to determinewhether an IP host is reachable.G On-Line SDLC PU Operations (Chapter 9)A Disable an SDLC PU – Takes any SDLC PU in the node off line.B Disable a Range of SDLC PUs – Takes a group of PUs off line.C Enable an SDLC PU – Brings any SDLC in the node on line.D Enable a Range of SDLC PUs – Brings a group of PUs on line.H NetView Access – (Appendix C) allows a NetView manager to obtaininformation on the node via NMVT commands or from files in the nodedatabase.I CSU/DSU Tests – is not used on the FRM.J Frame Relay Backup Operations – (Chapter 18) allows manual switching froma primary frame relay DLCI to its backup, or from the backup to the primary.A Initiate Switching Primary DLCI Over to its BackupB Initiate Switching DLCI Back to the PrimaryC Status Displays (Chapter 19)A Node Status – displays performance and link status for the node.B Port Status – displays port type, operational status, and link states for all portson the node.C Virtual Connections – displays DLCIs/LCNs, link states, subscribers, and(frame relay only) performance for all logical connections.D Port Signals – displays configuration data for each port on a specified RLP, andshows on/off status of each signal at the interface.E Traffic MonitorA Port Monitor – displays control and information data of all level-3 packetspassing through a specified port.B LAN Capture Status and Control Menu – allows configuration of parametersthat identify LAN cards and specify information to be captured whenmonitoring LAN traffic.C LAN Capture Review – displays captured LAN monitor information.F Protocol StatusA IPX RIP Table Display – displays the contents of the RIP table.B IPX SAP Table Display – displays the contents of the SAP table.C SDLC PU Status – displays a list of configured station addresses for aspecified SNA port, including current active/inactive states.D Bridge Status DisplaysA Bridge Port Status Display – displays a list of Bridge ports, includingtype, active status, bridge state (forwarding, listening, etc.), and numberof bytes received and transmitted.B Bridge Forwarding Table Display – displays a list of MAC addresses andtheir associated bridge ports, plus any flags that have been set.
