Configuring IP 13-5Configuring IP InterfacesAn IP interface on the FRM allows the Internet Protocol to be executed over framerelay, X.25, or LAN.To display all IP interfaces configured on the node, press [A] at the Configure IP/LLC2/BRIDGE/IPX Interfaces Menu (or [A], [C], [E], [A] from the Main Menu).To configure an interface, press [B] at the Configure IP/LLC2/BRIDGE/IPX Inter-faces Menu. When prompted, enter an interface number: 0–256. (This is merely asequential number to identify the interface.)It is a good idea to configure the LAN interface as interface 0. This ensuresthat the default IP address used for Unnumbered Interfaces (see page 13-11) will always be the same.The display depends on the interface; the following figure shows an example, andTable 13-2 (on page 13-7) through Table 13-4 (on page 13-9) list the parameters forall interface types.Figure 13-2 IP Interface Record – Frame Relay Example[A],[C],[E],[B] from Main MenuDestination IP Address is displayed only if Enable Inverse ARP is N.Source IP Address is displayed only if Unnumbered Interface is N.N ode N ame=nodexyzIP I nterface Con figu ration* In terface Nu mber: 10A Maximu m Trans mis sion U nit 4096B Rou tin g Metric Cou nt 0C IC MP Redirects YD RI P Su pport 0 En abledE RI P Flas h U pdates (sec) 60F RI P Full Upd ates (s ec) 120G Priority 5H Band width Allocation Group 1I In terface Type FRLJ Sou rce C ard 0K Sou rce Port 0L Sou rce D LCI 16M Enab le Inverse AR P NN Destination IP A ddress 100.100.2.1O Un numb ered Interface NP Sou rce I P Add ress 100.100.2.2Q Network Mask 255.0.0.0Op tion :