15-10 Frame Relay Module 4.0 User Guide, Rev 01Filter Namehelps the user identify the filter. The name is not used by the software.Protocol ID Valueis the IEEE 802 value of the protocol (SNAP or Type II) to which the filter will apply.Filter Namehelps the user identify the filter. The name is not used by the software.Source NetBIOS Nameshould be obtained from a system administrator.Destination NetBIOS Nameshould be obtained from a system administrator.Configuring Bridge Filter ApplicationsBridge Filter Applications determine how filters will be used at the interface. Toreview existing applications, press [H] at the Filter Definitions and Applications Con-figuration Menu (or [A], [A], [E], [F], [H] from the Main Menu). To configure an appli-cation, press [I] at the Filter Definitions and Applications Configuration Menu. Whenprompted, enter:l Bridge Port Number: 0–95. (The default is 0.) (This number simply identifies theinterface.)l Filter Type: 4 = Generic 5 = MAC (Default) 6 = LLC2 SAP7 = Protocol 8 = Bridged native NetBIOS.Table 15-5 Bridge Protocol Filter ParametersParameter Valid Values Default ValueFilter Name 1–31 characters noneProtocol ID Value 0–ffff (2 bytes) 0000Protocol ID Mask 0–ffff (2 bytes) 0000Table 15-6 Bridge NetBIOS Filter ParametersParameter Valid Values Default ValueFilter Name 1–31 characters noneSource NetBIOS Name 1–36 characters noneDestination NetBIOS Name 1–36 characters none