14-10 Frame Relay Module 4.0 User Guide, Rev 01IPX Interface ParametersTable 14-7 through Table 14-9 list parameters specific to frame relay, X.25, and LANinterfaces, respectively. Explanations of most parameters follow Table 14-9.Frame Relay Interface Parameters1 Default value is Ethernet or 802.5 (depending on hardware) for Interface 0, and FRL forInterface 1–63.2 If set to greater than 0 (see note 4), RIP Age Timer must be 3 times longer than PeriodicRIP Timer, and SAP Age Tim er must be 3 times longer than Periodic SAP Timer.3 A value of 0 disables aging.4 Make sure the port is not configured (in the Port record) for backup use only.5 Make sure the DLCI is not part of a frame relay DLCI backup group or intra-nodal framerelay PVC.Table 14-7 IPX Frame Relay Interface ParametersParameter Valid Values Default ValueBlocked Port Flag Y/N NInterface Type FRL Depends on inter-face number 1Frame Type TYPE_II TYPE_IIMaximum Transmission Unit (frame size) 31–4096 (bytes) 4096IPX Network Address 1–fffffffe 00000000Pr iority 0–9 5Bandwidth Allocation Group 1–16 1Port Diagnostics Enabled Y/N NNetBIOS Enabled Y/N NNetBIOS Hops 0–255 8Periodic RIP Enabled Y/N NPeriodic RIP Timer (seconds) 1–65535 2 60Periodic SAP Enabled Y/N NPeriodic SAP Timer (seconds) 1–65535 2 60RIP Enabled Y/N NRIP Age Timer (seconds) 0–65535 2,3 180RIP Maxim um Size (bytes) 54–446 446SAP Enabled Y/N NSAP Age Timer (seconds) 0–65535 2,3 180Transport Time (55ms ticks) 1–255 1Serialization Enabled Y/N NWatchdog Spoofing Enabled Y/N NIPXWAN Enabled Y/N NSource Card 0–2 0Source Port 0–7 4 0Source DLCI 16–991 5 16