2-6 9W004 4.0 User Guide, Rev 01Moving Through the MenusTo select a menu item, press the letter to the left of the item.To return to the next higher menu from a lower-level, press [F3].To move from operations under one Main Menu entry to operations under anotherentry, you must return to the Main Menu. The easiest way is to press [F3] repeatedlyuntil the Main Menu is displayed.PromptsWithin the menu operations, there are two kinds of prompts:l Information prompts – respond by typing the requested information, thenpressing [Enter].l Yes/no prompts – respond by pressing [Y] or [N].Throughout this manual are tables of valid and default values. To specify a default (ifone exists), press [Enter] in response to a prompt.Pressing [Enter] when it is not required may cause the nextprompt to automatically select the default choice.On-Line HelpMost screen menus display a prompt called Option:. Pressing [?] in response to thisprompt will usually display a list of options. To make a selection, press either thefunction key shown preceding the desired option or the character preceding thedesired menu item. The list of options varies, depending on what menu is displayed;most of the options are described below. (Function key equivalents on an async ter-minal keypad are listed on page 2-8.)F1: Select Another Record or Redisplay/Refresh:Next Record—displays the first prompt that appeared on your screen after youmade your menu selection, so you can specify another record.Redisplay/Refresh—refreshes a display with updated information.F2: Next Record or Remote Refresh:Next Record—displays the next sequential record on your screen for verification,modification, or deletion.Remote Refresh—refreshes a remote display.F3: Exit menu—returns you to the previous menu, saving any changes you have made.Some menus have two sets of values: Database and System Memory.Changes will affect only the database, unless you press [F7] beforepressing [F3] . (This will update the system memory.) Database andSystem memory values are described on page 4-3 for Node Defaultsand page 6-3 for Ports.