12-14 Frame Relay Module 4.0 User Guide, Rev 01Async PAD Typedefines the PAD type for transparent polled/multipoint async operation:0 = normal (X.3) 1 = HPAD 2 = TPADDevices Connectedis the number of devices connected to the async port. This value must be 1 for X.3PAD and TPAD.Assemble Full Messageassembles (if Y) incoming packets from the remote device (assuming M-bit is set) intoa complete message before forwarding it to the local async device.This function works only if the M-bit is set in packets from theremote device.Data Forwarding Criteriaspecifies (as currently implemented) that the async PAD profile parameters willdetermine when data is forwarded.Special Forwarding Charis not implemented in the current release.Dynamic Signaling Actionis not implemented in the current release.Configuring Subscriber IDsThis operation configures the called and calling addresses that will be used in X.25call setup if SNA is being transported over a logical X.25 port. To complete the con-nection, the software must recognize where the call is coming from (calling address)and where it is going (called address).To display a list of current Subscriber IDs (addresses), press [A] at the Connections andRouting Paths Menu (or [A], [D], [A] from the Main Menu).To add or change a Subscriber record, press [B] at the Connections and Routing PathsMenu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions aredescribed on on page 8-22.)
