3-10 Frame Relay Module 4.0 User Guide, Rev 01Where to Find Configuration InformationThe following shows where to find the various configuration files among the menus.(The first item, A–Configuration, is an entry on the Main Menu.) Following some itemsare the chapters/appendices in this manual where the items below those entries aredescribed. Following most items in the lower tiers are descriptions of the associateddatabase records.A ConfigurationA Configure NodeA Configure Password – (Chapter 2) allows changing the default loginpassword.B Configure Time and Date – (Chapter 2) allows setting a correct time/date that will be displayed on some screens and reports, and will allowall Cabletron frame relay access nodes on a network to be in sync,regarding reports and alarm messages that include the date and time.C Configure Node Defaults – (Chapter 4) specifies IDs and passwordsused for remote control, file transfer, and alarm routing and reportingoperations.D Configure SNMP Parameters – (Chapter 16) identifies the SNMPmanager; defines communities; SNMP trap routing, and hardwareplatforms (for identification by Netlink OmniView element manager).A Configure System DefaultsB Configure Community TableC Configure Trap RoutingD Configure Model NumberE Configure IP/LLC2/BRIDGE/IPX Default ParametersA Configure IP Node Defaults – (Chapter 13) specifies whether theFRM will act as an IP gateway and which version of RIP will beused.B Configure Bridge/LLC-2 Node Defaults – (Chapter 9) specifiesparameters that will be used internally by the node to identify avirtual bridge that will connect the LLC2 function to LANinterfaces and frame relay PVCs.C Review SNA LLC2 Hosts – (Chapter 9) displays any LLC2 hosts(see below) that have been configured on the FRM.D Configure SNA LLC2 Hosts – (Chapter 9) defines LLC2 hosts onthe FRM; includes session type (originated or terminated),necessary addresses, timers.E Configure IPX Node Defaults – (Chapter 14) defines operation ofthe FRM when used as an interface to a Novell NetWarenetwork.F Configure Filter Definitions and ApplicationsA Review IPX Filter Definitions – (Chapter 14) displays any IPXfilters (see next item) that are configured on the FRM.B Configure IPX Filter Definitions – (Chapter 14) specifiesparameters for transmission of RIP and SAP updates, and/orgeneric IPX packets, per interface and direction.C Review IPX Filter Applications – (Chapter 14) displaysinformation on any IPX filter applications (see below)configured on the FRM.D Configure IPX Filter Applications – (Chapter 14) applies IPXfilters to interfaces/filter types/directions.
