19-18 Frame Relay Module 4.0 User Guide, Rev 01Displaying Capture DataTo display captured LAN data, press [C] at the Traffic Monitor Menu. The display willbe similar to the following:Figure 19-9 LAN Capture Display[C],[E],[C] from Main MenuThe three numbers near the upper right identify (from left to right) the currentlyselected frame, the lowest sequence number (Num – see below) in the current buffer,and the highest sequence number in the current buffer.Information in this Display:l Num – a five-digit sequence number.l Time – the time to the hundredth of a second since the first "event" in the currentbuffer.l D – the data direction: I (incoming) or O (outgoing), plus the LAN card number.On monitors capable of displaying reverse video, outgoing frames will be dis-played in reverse video.l Type – the frame type: IP, IPX, Bridge, or Unknown.l Len – length of the frame.l Data – source MAC address, destination MAC address, frame type, and first 76bytes of the frame, in hex.Note that pressing [F7] will allow specification of an event (sequence) number to bedisplayed, in case that number is not currently on the screen. (It must, however, be inthe buffer.)The capture buffer can hold the first 76 bytes of each packet, up to 1000 packets. Thedata is stored in a file named landata.out.Nod e Name=nod e_xyzEvent 2 of 1: 6Nu m Time D Typ e Len Data------- -------- --- ------ ------ -------------------------------------------------------------00001 000.00 I0 I P 0100FFFFFFFFFFFF 0000C0D CBE28 0806 HDOHD HD NJJJFEFELMFFOFKOEKFOEKFOEKFOEKFOKEWFOKEFOKMFEMFOKF EWKFEWKFFLELF00002 002.40 O0 I P 0100FFFFFFFFFFFF 0000C0D CBE28 0806 HDOHD HD NJJJFEFELMFFOFKOEKFOEKFOEKFOEKFOKEWFOKEFOKMFEMFOKF EWKFEWKFFLELF00003 004.30 I0 I P 0100FFFFFFFFFFFF 0000C0D CBE28 0806 HDOHD HD NJJJFEFELMFFOFKOEKFOEKFOEKFOEKFOKEWFOKEFOKMFEMFOKF EWKFEWKFFLELF+ - PgU p,PgDn F3: Exit F4: Pu rge C apture F7: Go to ev #
