Configuring BSC Batch 11-7Subscriber ParametersSqis simply a line number to ease selection of a line on the screen to change. To move toanother line, press [A] and enter the sequence number.Local Subis the calling address used by the local device. A Subscriber ID record (see page 11-7) must also be configured for this address.Remote Subis the called address used for calls by the local device. A Subscriber ID record (seepage 11-7) must also be configured for this address.If the BSC port is one end of a connection to a logical X.25 port in the FRM, thisaddress must match a Subscriber ID configured for the logical port.Atcl(Autocall) causes a BSC device to automatically the remote end when it becomesactive.Rtytmis the Retry Timer, which determines the time between autocall retries.Rty#is the maximum number of times an autocall will be sent. Note that a value of 0 allowsindefinite retries.Dellets you delete the remote subscriber that is currently highlighted. You will beprompted: Delete "n," where "n" is the sequence number. Pressing [Y] will delete thatline and move all entries below it up one sequence number.Configuring Subscriber IDsThis operation configures the called and calling addresses that will be used in X.25call setup if BSCI is being transported over a logical X.25 port. To complete the con-nection, the software must recognize where the call is coming from (calling address)and where it is going (called address).To display a list of current Subscriber IDs (addresses), press [A] at the Connections andRouting Paths Menu (or [A], [D], [A] from the Main Menu).To add or change a Subscriber ID, press [B] at the Connections and Routing PathsMenu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions aredescribed on page 8-22.)
