19-2 Frame Relay Module 4.0 User Guide, Rev 01Displaying Port StatusPress [B] at the Status Displays Menu to display the status of all serial lines on thisnode (LAN port status is not displayed).Figure 19-2 Port Status Display[C],[B] from Main MenuInformation in this Display:l L – is the RLP number.l P – is the port number.l Type – is the port type:FRL = Frame relay X25 = X.25 SNA = SNABSI = BSC Interactive BSI = BSC Batch ASY = Async PADLOG = Logical Eth = Ethernet 8023 = 802.38025 = 802.5.l PPS – is packets per second passing through the port.l Conn# – is the number of virtual connections currently in use.l State: Linkup – The necessary level 1 modem signals are present, and the level2 link is up. (For frame relay PVCs, this state means that LMI is running.)Restarting – Level 2 is up and level 3 is starting its initial handshakesequence.Operational – The line is up and ready to establish a connection or transferdata. On a frame relay logical DTE port with link layer management con-figured, this state means that the port has received a Full Status Responsefrom the DCE (frame relay switch), as a result of a Full Status Enquirysent by the FRM.On a frame relay logical DCE port, this state means that the port hasreceived a Full Status Enquiry from the attached DTE.N ode Name=n ode_xyzPort S tatus Disp lay (Page 1)L P Type PPS Con n# State L P Type PPS C onn# State0 0 X25 62 4 Op erational 0 1 X25 127 12 Op erational0 2 X25 112 7 Op erational 0 3 X25 60 6 Op erational0 4 SNA 110 3 Op erational 0 5 X25 87 5 Op erational1 0 ASY 0 0 Disabled 1 1 X25 88 4 Op erationalEthern et
