17-4 Frame Relay Module 4.0 User Guide, Rev 01E Frame Relay Backup Status – displays the current state of frame relayprimary and backup DLCIs.A Display States for all Backup DLCIs on a PortB Display States for all Primary DLCIs on a PortC Display States for all Backup DLCIs in a GroupF LLC/2 Session Status – displays addresses and operational states of allcurrent LLC2 sessions.G IP Status DisplaysA IP Routing Table Display – displays interfaces, destinations, networkmasks, and flags.B IP ARP Table Display – displays ARP IP addresses, MAC addresses, andaging timers.C IP Interfaces Display – displays interface names, MTU values, networknames, masks, IP and remote addresses, and flags.D Events – (Chapter 21) Displays event (alarm) messages as they occur.E Statistics (Chapter 20)A Configure RLP / Port Thresholds – allows creation of a threshold for a statisticthat, when crossed, will cause an alarm to be generated.B Display RLP / Port / Frame Statistics – displays the supported statistics for thespecified component, showing current values, as well as the highest valuesreached by each statistic since the node was last booted or since maximumvalues were last cleared.C Display IP Statistics – displays the supported statistics, including current valuesand cumulative values since maximum values were last cleared.D Display ICMP Statistics – displays the supported statistics, including currentvalues and cumulative values since maximum values were last cleared.E Display IP Interface Statistics – displays the supported statistics, includingcurrent values and cumulative values since maximum values were lastcleared.F Display IPX Interface Statistics – displays the supported statistics, includingcurrent values and cumulative values since maximum values were lastcleared.G Display LAN Card Interface Statistics – displays the supported statistics,including current values and cumulative values since maximum valueswere last cleared.H Display Frame Relay Utilization Statistics – displays CIR, B C, and B E values fora specified DLCI, as well as the configured and actual percentages ofbandwidth use by each bandwidth allocation group.F ReportsA Create Configuration Report – (Chapter 3) produces a summary of all databaserecords in the node.B View Configuration Report – (Chapter 3) displays the above summary.C View Initialization Report – (Chapter 2) produces a list of messages createdduring the current boot-up of a node.D View Previous Initialization Report – (Chapter 2) produces a list of messagescreated during the previous boot-up of a node.
