Configuring Frame Relay 7-9Configuring Frame Relay PortsOnce the necessary Node and RLP parameters have been configured, press [A] at thePort Configuration Menu (or [A], [C], [A] from the Main Menu. When prompted, enter:l RLP containing the port: 0–2. (The default is 0.) (RLP locations are shown inFigure 6-1.)l Port: 0–7. (The default is 0.) (Port locations are shown in Figure 6-2.)The display for an existing port will show the configured parameter values, while thedisplay for a new port will show default database values. (See Table 7-3 on page 7-14and Table 7-4 on page 7-15.) The following figure is an example of an existing port.Figure 7-3 Frame Relay Port Screen 1[A],[C],[A] from Main MenuAfter making any changes, be sure to press [F7] to update thesystem memory. Otherwise, the changes will not take effect untilthe next re-boot of the FRM.Pressing [O] will display a screen similar to the following.N ode Name=n ode_xyzFrame Relay Port Parameters (screen 1 of 2)* RLP: 0 Port: 0 Link State: Linku p* I/O: V .35D atabase Sys tem MemoryA Port Type Frame Relay Frame RelayB Ph ysical Port I nterface V .35 V.35C Blocked Port Flag N ND Lin e Sp eed 64K b ps 64K b psE Maximum Bytes p er Frame 1600 1600F Logical D CE N NG Generate Clock N NH Rcv C lock (TT) from D TE N NI Lin k Man agement 2 Ann ex D 2 Ann ex DJ N1 Pollin g Cou nt 6 6K N2 Error Threshold 3 3L N3 Mon itored Events C ount 4 4M T1 Link In tegrity Timer 10 10N T2 Polling Verification Timer 15 15O Add itional ParametersOption: