19-6 Frame Relay Module 4.0 User Guide, Rev 01Displaying Port SignalsThis display lists basic configuration and line status for all serial ports on a specifiedRLP, as well as signal states (on/off) at the physical interfaces.Press [D] at the Status Displays Menu and, when prompted, enter an RLP number:0–2. The display will show the first four ports, and pressing [PgDn] will display theother four ports.Figure 19-5 Port Signals Display[C],[D] from Main MenuInformation in this Displayl Port Number – is self-explanatory.l Phy Interface – is the type of connector on the I/O cable exiting the port's I/O boxconnector toward the subscriber device. (This information is taken from the Portrecord.)l Port Config – is the port type (FRL, SNA, X25, etc.) as configured in the Portrecord. If no record has been created for this port, No Config is displayed on thisline and the one below it.l Logical Inter – is the logical interface, DCE or DTE , as taken from the Port record.If no record has been created for this port, No Config is displayed on this line andthe one above it.l Line Speed – is the speed configured in the Port record.l Line Status: Failed (level 2 is down)Disconnect (level 2 is up; level 3 is down)Restart (level 3 is restarting)Not_configured (port is not configured)Operational (level 3 is up)Nod e Name=nod e_xyzLine Process or Status RLP: 0 I nterface: RS -422Port Nu mber: 0 1 2 3Phy Interface: X .21 R S-449 X.21Port Con fig: FR No SN A FRLogical Inter: DTE Config D CE DCELine S peed : 1.008M 1.472M 2.048MLine S tatus: Oper Op er OperTD(2) ON ON ONRD (3) OFF ON ONRTS (4) OFF ON ONCTS (5) OFF ON ONDS R(6) ON ON ONDC D(8) ON ON ONTC(15) ON ON ONRC (17) ON ON ONDTR (20) ON ON ON \F2:Next R LP Card F9:Stop R emote F10:A bort RemotePgUp:Firs t 4 Ports PgDn :Last 4 Ports Oth ers:Exit08:14:52