12-8 Frame Relay Module 4.0 User Guide, Rev 01Configuring Async Port RecordsOnce the necessary Node, Line Processor, and protocol parameters have been con-figured, press [A] at the Port Configuration Menu (or [A], [C], [A] from the Main Menu.When prompted, enter:l RLP containing the port: 0–2. (The default is 0.) (RLP locations are shown inFigure 6-1.)l Port: 0–7. (The default is 0.) (Port locations are shown in Figure 6-2.)The display for an existing port will show the configured parameter values, while thedisplay for a new port will show default database values. (See Table 12-3 on page 12-9.) The following figure is an example of an existing port.Figure 12-2 Async PAD Port Screen[A],[C],[A] from Main MenuIf a record does not exist for the async PAD profile identified by InitialProfile Name, the letter U will be displayed preceding the name in theDatabase column.After making any changes, be sure to press [F7] to update thesystem memory. Otherwise, the changes will not take effect untilthe next re-boot of the FRM.Pressing [J], [K], [M], [N], or [O] will display more parameters, listed in Table 12-3 (onpage 12-9). Pressing [L] will display the async PAD profile parameters (listed earlierin this chapter) that are resident in the FRM software.Nod e Name=n odexyzA sync PAD Port Parameters* RLP: 0 Port: 0 Link State: Lin kup* I/O:–R S-232Datab ase Sys tem MemoryA Port Typ e As ync PAD As ync PADB Ph ysical Port I nterface RS -232 RS -232C Blocked Port Flag N ND X.3 Line Sp eed autob aud autob audE Initial Profile Name 90 90F Login Requ ired N NG Parity 0,n one 0,n oneH DCE Cable A ttach ed N NI Mas k Link A larms N NJ X.25 Parameter Op tion sK Autocall Op tion sL Brow se ProfileM Mod em Signal OptionsN Disconnect OptionsO Asyn c PA D Op tion sOption:
