6-4 Frame Relay Module 4.0 User Guide, Rev 01Figure 6-3 Default Configuration Screen for New Port[A],[C],[A] from Main MenuAfter making any changes, be sure to press [F7] to update thesystem memory. Otherwise, the changes will not take effect untilthe next re-boot of the FRM.The entry I/O identifies the LIC containing the port, and Link State will be one of these:Link_disable – The link was shut down by an on-line command, is undergoing re-IPL, or has not yet been established.Failed – Some or all modem controls are missing. (This state is passed throughwhile a port is becoming enabled.)Link_down – The link was up, but has gone down.Disconnect – Level 2 cannot be established.Linkup – The necessary level 1 modem signals are present, and level 2 link is up.NA – Some state other than those above has been entered.To configure the port with the parameter values neccessary for your application, go tothe appropriate chapter:l Frame relay – Chapter 7l X.25 – Chapter 8l SNA – Chapter 9l BSCI – Chapter 10l BSCB – Chapter 11l Async – Chapter 12Configure the protocol that will run over the physical port.Rmtid=nod exyzX.25 Port Parameters (screen 1 of 6)* R LP: 0 Port: 5 Lin k S tate: Lin k_disab le* I /O: V.35Databas e System MemoryA Port Type X.25 X.25B Phys ical Port In terface V.35 V.35C Blocked Port Flag N ND Line S peed 9600 bp s 9600 bp sE Modu lo 8 8F Maximum LA PB Window Size 7 7G N 2 Retransmit Coun t 5 5H T1 Retran smit Period (msec) 2000 2000I T2 Wait Ack Period (ms ec) 1000 1000J T3 Lin k Alive Period (sec) 10 10K Logical DCE N NL Generate C lock N NM R cv Clock (TT) from DTE N NOption:
