S.2011001 [S.2011001]Explanation: An Uncorrected PCIe Error has Occurred at Bus % Device % Function %. The Vendor ID for the deviceis % and the Device ID is %. PCI SERR DetectedSeverity: ErrorUser response: Complete the following steps:1. Check IBM support site for an applicable device driver, firmware update, version of service information for thisproduct or other information that applies to this error. Load new device driver and any required firmwareupdates.2. If this node and/or any attached cables were recently installed, moved, serviced or upgraded, a. Reseat Adapterand any attached cables. b. Reload Device Driver c. If device is not recognized, reconfiguring slot to Gen1 orGen2 may be required. Gen1/Gen2 settings can be configured via F1 Setup -> System Settings -> Devices and I/OPorts -> PCIe Gen1/Gen2/Gen3 Speed Selection, or the ASU Utility.3. If problem persists, then remove Adapter Card. If system reboots successfully without the adapter, replace thatcard.4. If problem persists, then replace the I/O book with the PCIe slot in question.5. If problem persists, then replace the compute book associated with the PCIe slot.6. (Trained Service technician only) Replace the processor.S.2018001 [S.2018001]Explanation: An Uncorrected PCIe Error has Occurred at Bus % Device % Function %. The Vendor ID for the deviceis % and the Device ID is %. PCIe Uncorrected Error DetectedSeverity: ErrorUser response: Complete the following steps:1. Check IBM support site for an applicable device driver, firmware update, version of service information for thisproduct or other information that applies to this error. Load new device driver and any required firmwareupdates.2. If this node and/or any attached cables were recently installed, moved, serviced or upgraded, a. Reseat Adapterand any attached cables. b. Reload Device Driver c. If device is not recognized, reconfiguring slot to Gen1 orGen2 may be required. Gen1/Gen2 settings can be configured via F1 Setup -> System Settings -> Devices and I/OPorts -> PCIe Gen1/Gen2/Gen3 Speed Selection, or the ASU Utility.3. If problem persists, then remove Adapter Card. If system reboots successfully without the adapter, replace thatcard.4. If problem persists, then replace the I/O book with the PCIe slot in question.5. If problem persists, then replace the compute book associated with the PCIe slot.6. (Trained Service technician only) Replace the processor.S.2011001 • S.20180011674 System x3850 X6 and x3950 X6 Types 3837 and 3839: Installation and Service Guide
