9. Remove the storage book board (see “Removing the storage book boardassembly” on page 268.10. Remove the backplanes (see “Removing the 4x2.5-inch hot-swap drivebackplanes” on page 235 and “Removing the 8x1.8-inch hot-swap drivebackplane assembly” on page 237).11. Remove the front operator panel (see “Removing the front operator panelassembly” on page 270).12. Remove the front I/O panel (see “Removing the front I/O panel (USB/video)assembly” on page 264).13. If you are instructed to return the assembly, follow all packaging instructions,and use any packaging materials for shipping that are supplied to you.Replacing the storage bookUse this information for instructions on how to replace the storage book.Note: .v For additional information, see “Storage book” on page 24v The PCIe slots on this storage book only support storage host bus adapters. Donot install any other adapters in these slots. Other adapters are not supported onthis storage book.v You must power-off the server to remove or add adapters in the PCIe slots onthe storage book. The PCIe slots are not hot-swappable.v Slot 12 (the primary storage slot) is connected to compute book 1 and slot 11(the secondary storage slot) is connected to compute book 2.v The PCIe slots on this storage book only support low profile RAID adapters andhost bus adapters.v Install internal RAID adapters and the adapter batteries or flash power modulesin the storage book component.To replace the storage book, complete the following steps:1. Install the front operator panel on the new storage book (see “Replacing thefront operator panel assembly” on page 272).2. Reinstall the front I/O panel (see “Replacing the front I/O panel (USB/video)assembly” on page 265).3. Reinstall the drive backplanes (see “Replacing the 4x2.5-inch hot-swap drivebackplanes” on page 236 and “Replacing the 8x1.8-inch hot-swap drivebackplane assembly” on page 238).4. Reinstall the storage book board. (see “Replacing the storage book boardassembly” on page 269).5. Reinstall the flash power modules, if any were removed (6. Reinstall the adapters (see “Adapter installation instructions” on page 92).7. Reconnect the cables to the adapters, the drive backplanes, and the storagebook board.8. Reinstall the storage book. Grasp the storage book and align it with the bayon the front of the server and slide the storage book into the server. Place onehand under the center of the storage book to support it while sliding it intothe server.Chapter 6. Removing and replacing components 267
