Parameter Declaration Data type DescriptionDuration INPUT TIME Time for the duration the Output is deactivatedrespectively PulseOff is activated.With 0ms the automatic switch off is deactivated.Default: 0msOutput OUTPUT BOOL Static output to drive a monostable relay.PulseOn OUTPUT BOOL Pulse output to control the bistable relay (Onsignal).PulseOff OUTPUT BOOL Pulse output to control the bistable relay (Offsignal).TimeDebounce CONSTANT TIME Time for debounce of the inputs.Default: 100msTimePulse CONSTANT TIME Time for the pulse duration of PulseOn respec-tively PulseOff.Default: 100msTimePause CONSTANT TIME Time for the break between resetting and settingof PulseOn respectively PulseOff.Default: 100ms7.2.2 FB 46 - BLIND - Controlling blindWith this block a motorized blind can be controlled. For this you have to release the drivewith Enable.n The controlling for “lifting” BlindUp and “sinking" BlindDown happens by 2 buttons(Up/Down respectively CentralUp/CentralDown).– CentralUp/CentralDown: Used for central control of all blinds in a building.– Up/Down: Used for local control of a blind. Here a pending CentralUp/Central-Down signal is ignored.n If the corresponding button is pressed longer as the specified TimeShortLong theblend drive moves to the respective end position. By pressing on of the two buttons(Up/Down respectively CentralUp/CentralDown) you can stop the movement andreverse, it if necessary.n With TimeMaxDuration you can specify the maximum run time of the motor and withTimePause you can specify the pause for the change of direction.n By jogging the blend drive shortly moves. With this function you can adjust the blindslats fine.n With TimeDebounce you can specify a debounce time for the input signals.n With Status you can check the position of the blend.– 0: Upper limit position– 50: Unknown position between the two limit positions– 100: Lowest limit positionCAUTION!The blend drive must have its own limit switches that turn off power auto-matically!DescriptionVIPA SPEED7Building ControlRoom > FB 46 - BLIND - Controlling blindHB00 | OPL_SP7 | Operation list | en | 18-30104
