ERROR = TRUE indicates that an error has occurred during processing. For details referto parameter STATUS. The following table contains all the error information specific toSFB 34 that can be output with the ERROR and STATUS parameters.ERROR STATUS(decimal)Description0 11 Message lost: The previous signal change or the previous message could not besent and will be replaced by the current message.0 22 The actual parameter you have selected for SEVERITY is higher than the per-mitted range. The activated message is sent with SEVERITY = 127.0 25 Communication was initiated. The message is being processed.1 1 Communication problems: Communications problems: connection abort or nologon With acknowledgement-triggered reporting active: temporary display, if nodisplay devices support acknowledgement-triggered reporting.1 4 At the first call, the specified EV_ID is outside the permitted range.1 10 Access to local user memory not possible (for example, access to a deleted DB)1 12 When the SFB was called: an instance DB that does not belong to SFB 34 wasspecified or a shared DB instead of an instance DB was specified.1 18 EV_ID was already being used by one of the SFBs 31 or 33 ... 36.1 20 Not enough working memory.1 21 The message with the specified EV_ID is disabled.After the first block call. all the bits of the ACK_STATE output are set andit is assumed that the previous values of inputs SIG_i, 1≤ i ≤ 8 were 0.14.2.15 SFB 35 - ALARM_8P - Messages with associated values (8x)Generating block-related messages with associated values for 8 signals.n SFB 35 ALARM_8P represents a linear extension of SFB 33 ALARM to 8 signals.n As long as you have not enabled acknowledgement triggered reporting, a messagewill always be generated when a signal transition is detected at one or more signals(exception: a message is always sent at the first block call). All 8 signal are allocateda common message number that is split into 8 sub-messages on the displayingdevice. You can acknowledge each individual message separately or a group of mes-sages.n You can use the ACK_STATE output parameter to process the acknowledgementstate of the individual messages in your program. If you disable or enable a messageof an ALARM_8P block, this always affects the entire ALARM_8P block. Disablingand enabling of individual signals is not possible.n One message memory with 2 memory blocks is available for each instance of SFB35ALARM_8P.Error information ERROR /STATUSDescriptionParameterVIPA SPEED7Integrated StandardSystem Function Blocks > SFB 35 - ALARM_8P - Messages with associated values (8x)HB00 | OPL_SP7 | Operation list | en | 18-30756
