STATUS Description080Ch Wrong character received(Character frame or parity error)8090h HW_ID is unknown.80A0h When accessing the periphery, an access error was detected.80A1h8181h Job is running (status and no error message).8323h Receive DB available, but too short.833Ah Receive DB not readable (DB not available or DB in optimizedblock access).Ä Chap. 2.3 ‘No optimized block access’ page 16n The DONE_SEND output shows "send order finished without error / data kept".n The NDR_RCV output shows "receive order finished without error".n If there was ERROR_SEND or ERROR_RCV, the corresponding event number is dis-played in the STATUS_SEND, STATUS_RCV. If no error occurs the value ofSTATUS_SEND and STATUS_RCV is 0000h.n DONE_SEND, NDR_RCV, ERROR_SEND, ERROR_RCV and STATUS_SEND,STATUS_RCV are also output in response to a reset of the FB. In the event of anerror, the binary result BR is reset. If the block is terminated without errors, the binaryresult has the status "1".n Please regard the parameter DONE_SEND, NDR_RCV, ERROR_SEND,ERROR_RCV and STATUS_SEND, STATUS_RCV are only available at one blockcall. For further evaluation these should be copied to a free data area.10.3 CP24010.3.1 FC 0 - SEND_ASCII_STX_3964 - Send to CP 240This FC serves the data output from the CPU to the CP 240. Here you define the sendrange via the identifiers _DB, ABD and ANZ. Via the bit FRG the send initialization is setand the data is send. After the data transfer the handling block sets the bit FRG backagain.ParameterName Declaration Type DescriptionADR IN INT Periphery address_DB IN BLOCK_DB /DB_ANY_DBn DB number of Type BLOCK_DB containing datato send, used in CPUs from VIPA or in S7-300CPUs from Siemens.n Pointer of Typ DB_ANY to the DB containingdata to send, used in S7-1500 CPUs from Sie-mens.ABD IN WORD Number of the 1. data word.ANZ IN WORD Number of bytes.Error indicationDescriptionVIPA SPEED7Serial CommunicationCP240 > FC 0 - SEND_ASCII_STX_3964 - Send to CP 240HB00 | OPL_SP7 | Operation list | en | 18-30230
