Eaton Scantronic i-on10 Configuration Manual

Also see for Scantronic i-on10: Installation instructions

Configuring the System − Getting StartedPage 196. Choose the language:From this point on, the display operates in the selected language. If you want tochange the language later, use Installer menu – System Options – Updates –Language.7. Choose the country version you want to use:8. Select the wiring type to use for wired zones:Further information about zone wiring types is given on page 14.Note: If you are using an ADP-10CC board (to provide ten on-board 4-wire CC zonesinstead of ten FSL zones), select 2-wire FSL 2k2/4k7 as the wiring type.Note: You can change this setting later using Installer menu – System Options.9. If you selected the UK as the country version, specify the alarm confirmation mode:Please refer to page 52 if you need information about confirmation modes. You canchange this setting later using Installer menu – System Options – Confirmation –Confirmation Mode.10. User codes (e.g. to set or unset the system) can be four or six digits long. Select therequired length:Note: You can change this setting later using Installer menu – System Options –Restore Defaults – Staged Defaults – Users.11. Specify an installer code:When prompted, confirm the code. DO NOT FORGET THIS CODE!12. Specify a code for the default master user:When prompted, confirm the code. DO NOT FORGET THIS CODE!13. You will see one of the following: If the lid of the control unit is closed, you will see the standby screen. Forexample:You can change the wiring type by pressing  one or moretimes. Press  to continue.Press  if you want to select six-digit user codes. Press  tocontinue. (The Follow Panel Grade option sets user codes to thedefault length for the panel grade, which for i-on10 is four digits.)Use the numeric keys to specify the code.You can change the country by pressing  one or more times.Press  to continue.You can change the language by pressing  one or more times.Press  to continue.You can change the confirmation mode by pressing  one or moretimes. Press  to continue.