Eaton Scantronic i-on10 Configuration Manual

Also see for Scantronic i-on10: Installation instructions

Page 66Appendix A: Log MessagesIntroductionThis Appendix gives short explanations of the messages that may appear in the controlunit’s log.Please note that many of the messages refer to specific devices by the bus and devicenumber. Therefore, it is not possible to show in this list the exact log message that youmay be seeing on any given installation.The list itself is sorted alphabetically by the text of the message. In the column “Event LogText” you will see “==” or sometimes “#”. These characters stand in for the zone, user ordevice number that the control unit has recorded for the event being logged. In the“Description” column this is shown as “n”.Log messagesEvent Log Text(Scantronic)Description"== Ex Keys Rstr" Excess keys (code attempts)tamper restore"24hr Z=== Alarm" 24 hour alarm on zone n"24hr Z=== Restore" 24 hour alarm on zone n restored"A/C Fail" AC mains failed and wascommunicated"A/C Restore" AC mains was restored"Alarm Abort U--" Alarm aborted by user n"Alarm Conf ==ER" Alarm has been confirmed by amissing external prox reader onkeypad n"Alarm Conf Bell #" Confirmed alarm with tamper onBell n"Alarm Conf. ==" Confirmed alarm with tamper onkeypad n"Alarm Confirm Z==" Confirmed alarm on zone"Alarm Confirm" Confirmed alarm"Alm Conf Bus# Tamp" An alarm was confirmed by a bustamper"Alm Conf Panel Lid" Confirmed alarm with tamper oncontrol unit lid"ATE L.F. All" All lines to alarm transmissionequipment failed"ATE L.F. Restore" Line to alarm transmissionequipment restored"ATE L.F. Single" Alarm transmission equipment hasa single line fault"Auxiliary 12V Fail" Control unit 12V Aux DC notworking"Auxiliary 12V Rstr" Control unit 12V Aux DC restored"Bad checksum" There is an error on loading thecontrol unit with its software"Batt = Fault Rst" Control unit battery restored"Batt = Low/Missing" Control unit battery missing or low"Bell # 12V Fail" 12V DC supply to bell n failed"Bell # 12V Restore" 12V DC supply to bell n restored"Bell # Tamper Rstr" External wired siren n tamperrestored"Bell # Tamper" External wired siren n tamper"Burg Z== Alarm" Burglar alarm on zone n"Burg Z== Restore" Burglar alarm on zone n restored"Burg Z=== Alarm" Burglar on First linked zone n inBeam Group"Burg Z=== Restore" Burglar on First linkedzone n inBeam Group restored"Bus # 12V Fail" 12V DC supply to Bus n failed"Bus # 12V Restore" 12V DC supply to Bus n restored"Bus # Tamper Rstr" Bus n has been restored"Bus # Tamper" Bus n has been tampered (forexample wires cut or disconnected)"Codes Defaulted" All access codes were returned tofactory defaults"Configuration Fail" The current configuration is notcompatible with the softwarerevision level of the control unit"Defaults Loaded" The control unit was returned tofactory defaults"Disabled ==" Keypad n disabled"Dup. == Restore" Duplicate keypad restored"Duplicate ==" Duplicate keypad n detected"Enabled ==" Keypad n enabled"Entry Started Z==" Entry started by zone n