Eaton Scantronic i-on10 Configuration Manual

Also see for Scantronic i-on10: Installation instructions

Page 25Chapter 4: Detectors/Devices MenuThis chapter explains the options in the Detector/Device menu.DetectorsProgram ZonesYou can program (configure) each zone's behaviour at any time, whether or not a wireddetector is connected.When you enter the menu, you will see the current configuration of Zone 0:Use  or  to select the zone you wish to configure, then press .Note: If a wired zone does not have a detector connected to it, make sure that its zonetype is Not Used (the default).NameYou can give each zone a name of up to 40 characters. The control unit displays thisname when, for example, you select the zone or the zone generates an alarm.TypeThe list below shows the available zone types.Note: When configuring zone types, the display shows a “*” to the left of the zone’scurrent type. You can select a zone type quickly by entering the two-digit shortcut number shownin brackets after the type’s name in the list below. For example, enter “05” to selectFinal Exit. The number does not appear on the display. The abbreviation of the type name (e.g. HUA) appears in the top-right corner of thedisplay when you select a zone. When several zones are activated at the same time, the control unit processes HoldUp Alarm and Normal Alarm zones first, followed by Fire, and then all other alarmtypes. The control unit always processes alarms before alerts.Not Used - NU (00)The alarm system will not respond when an event triggers this detector. This is thedefault zone type for all zones.This is the current "zone type". "NU" means "Not Used".This is the zone number (0-9).This is the current name of the zone.