Eaton Scantronic i-on10 Configuration Manual

Also see for Scantronic i-on10: Installation instructions

System Options MenuPage 49Terminated Set(This option is relevant if you are using a KEY-EP external proximity readerconnected to a keypad.)Yes – Select this if you want to start the setting procedure from a keypad andcomplete it at the KEY-EP. You will not be able to start the setting procedure from theKEY-EP. For this setting, also configure Setting Options – Full/Part Set – Exit Modeto Exit Terminate.No – Select this if you want to able to start the setting procedure from the KEY-EP (orfrom a keypad). In this case, choose an exit mode such as Timed Set or Instant Set.When you present the proximity tag to the KEY-EP, the system sets with no furtheraction.For both settings of Terminated Set, presenting a tag to the KEY-EP when thesystem is set immediately unsets the system.Tamper OmitIf a user omits a zone, it may be necessary also to omit the tamper belonging to thatzone.Yes – The tamper is omitted when a user omits a zone.No – The user cannot omit a tamper on a zone.Silence AlertsThis option controls the length of time that keypads and loudspeakers give the alerttone (a brief ‘beep’ every second) when there is an alert.Note: Some alerts are associated with a specific part of the system (such as an alertgenerated by a detector of type Technical Alarm that is in a part set). Other alertsare associated with the whole system (such as an alert generated by a lowbackup battery). An alert is not sounded if all part sets the alert is associatedwith are set. Keypad navigation keys glow red when there is an alert sounded at the keypad(or if there would have been an alert sounded if had not been for the selection ofNo Alert Tones).User Code – The alert tone is sounded until a user keys in an access code toacknowledge the alert.30/60/120 minutes – The alert tone is sounded for the selected time. The alert tonestops if a user enters a valid access code.No Alert Tones – There is no alert tone.User ResetThis option determines under what circumstances a user or the installer can reset thesystem after an alarm.Zone AlarmsThis appears when System Options – Confirmation – Confirmation Mode is set toBasic (page 52).Yes – The user can reset the system after an alarm triggered by a zone’s alarmcircuit.No – The installer must reset the system after an alarm triggered by a zone’s alarmcircuit. See also “Remote Reset” on page 50.