Eaton Scantronic i-on10 Configuration Manual

Also see for Scantronic i-on10: Installation instructions

Detectors/Devices MenuPage 37To replace a keypad:1. Select Replace Keypad at another keypad, and choose the keypad to replace. Whenprompted, confirm the replacement.2. Pair the replacement keypad with the base station.3. Select Replace Keypad again, and choose the keypad you replaced (the displayshows "Add" in the bottom-right corner).4. Hold down the A and  keys at the new keypad. The control unit assigns the busdevice address of the keypad you removed to the new keypad, along with the nameand other settings from the old keypad. The new keypad will not need any furtherconfiguration.The control unit assigns the bus device address of the keypad you removed to thenew keypad, along with the name and other settings from the old keypad. The newkeypad will not need any further configuration.