Eaton Scantronic i-on10 Configuration Manual

Also see for Scantronic i-on10: Installation instructions

System Options MenuPage 50Note: Users can reset the system if they unset the system during an alarm, butbefore the Alarm Abort period has expired (see page 57).Zone TampersYes – The user can reset the system after an alarm caused by a zone’s tampercircuits being triggered.No – The installer must reset the system after an alarm caused by a zone’s tampercircuits being triggered. The alarm abort period does not apply.System TampersYes – The user can reset the system after an alarm caused by a system tamper.No – The installer must reset the system after a system tamper alarm. The alarmabort period does not apply.A system tamper can be caused by, for example: Operating a lid/back tamper switch on a device. Applying a voltage higher than approximately 4V to the TR input from an externalsounder.If a tamper occurs when the system is set, the control unit classifies this as anunconfirmed or confirmed alarm. The reset follows the alarm reset option NOT thetamper.Remote Reset (RedCare Reset)If you select NO for System Tampers, then when a tamper occurs, the control unitenables the Remote Reset input pin on the plug-by connector. After an alarm, theuser may silence the sounders, but to reset the system, the user must first contactthe ARC. The ARC (after verifying the user’s identity) can cause the Remote Resetinput to go to +12V by way of the plug-by communicator. On receiving the signal, thecontrol unit allows the user to reset the system.If the ARC causes Remote Reset to go to +12V and it reverts back to 0V before theuser resets the system, the control unit remembers that the signal has been sent andstill allows the user to reset the system using their normal access code.Code TampersYes – The user can reset the system after an alarm caused by a code lockout (seepage 21).No – The installer must reset the system after an alarm caused by a code lockout.Keypad TextThis allows you to specify the text that appears on the first line of the display in thestandby screen (such as your company name). See page 22 for editing text.Restore DefaultsStaged DefaultsThis menu option allows you to default parts of the control unit’s configuration withoutaffecting the whole system. You can choose to default the following:UsersDefaults (removes) all user access codes and proximity reader tags, including for themaster user. You are prompted to enter a new code for the master user.You can also choose whether to use 4-digit or 6-digit codes.