Eaton Scantronic i-on10 Configuration Manual

Also see for Scantronic i-on10: Installation instructions

Introduction to i-on10Page 9The keypads supported by i-on10 are listed in Table 2. Many of these include a built-inproximity reader, which allows users to set or unset the system using a proximity tag.Note: i-on10 does not support zones and outputs connected to a keypad.Note: Do not install a proximity reader closer than one meter to any other type of proximityreader, otherwise the devices may not work correctly.Table 2: Keypad featuresFeatureKEY-K01i-kp01KEY-KP01KEY-KPZ01KEY-FKPZKEY-RKPZ*Wired keypad Yes Yes Yes Yes Yes NoRadio keypad No No No No No YesBuilt-in proximity reader No Yes Yes Yes Yes YesKEY-EP external proximity reader terminals No No Yes Yes Yes NoZones (not supported with i-on10) 0 0 0 2 2 2Outputs (not supported with i-on10) 0 0 0 1 1 0Loudspeaker terminals 0 0 0 0 1 0Two-line by 20-character backlit LCDdisplay Yes Yes Yes Yes Yes YesIlluminated four-way switch (the “navigationkey”), which is used to navigate throughmenusYes Yes Yes Yes Yes YesLEDs behind the navigation key to show thefault status of the system Yes Yes Yes Yes Yes YesNumeric keypad for entering access codesand keying in text Yes Yes Yes Yes Yes YesDedicated A, B, C and D keys, which can beprogrammed to set individual part sets, orallocated to control an output.Yes Yes Yes Yes Yes YesKeys for “yes”, “no” functions Yes Yes Yes Yes Yes YesUnset key Yes Yes Yes Yes Yes YesHold-Up Alarm (HUA) keys Yes Yes Yes Yes Yes YesUser menu key and an automatic timeoutfrom the user menu Yes Yes Yes Yes Yes YesInternal sounder to give setting tones, alarmsounds, etc Yes Yes Yes Yes Yes YesBacklit keys Yes Yes Yes Yes Yes Yes*The KEY-RKPZ is a two-way battery-powered radio keypad. This keypad communicatesover a radio link to a base station connected to the bus, which acts as a communicationsbridge between the keypad and the control unit. You can use a KEY-RKPZ in the sameway as a wired keypad to configure the system, set or unset the system, etc.KEY-EP external proximity tag readerA KEY-EP external proximity tag reader can connect to a KEY-KP01, KEY-KPZ01 orKEY-FKPZ keypad to enable the system to be to set or unset externally.