Eaton Scantronic i-on10 Configuration Manual

Also see for Scantronic i-on10: Installation instructions

Page ii© Eaton 2022The information, recommendations, descriptions and safety notations in this document are based on Eaton Corporation’s (“Eaton”)experience and judgment and may not cover all contingencies. If further information is required, an Eaton sales office should beconsulted. Sale of the product shown in this literature is subject to the terms and conditions outlined in appropriate Eaton selling policiesor other contractual agreement between Eaton and the purchaser.THERE ARE NO UNDERSTANDINGS, AGREEMENTS, WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING WARRANTIES OFFITNESS FOR A PARTICULAR PURPOSE OR MERCHANTABILITY, OTHER THAN THOSE SPECIFICALLY SET OUT IN ANYEXISTING CONTRACT BETWEEN THE PARTIES. ANY SUCH CONTRACT STATES THE ENTIRE OBLIGATION OF EATON. THECONTENTS OF THIS DOCUMENT SHALL NOT BECOME PART OF OR MODIFY ANY CONTRACT BETWEEN THE PARTIES.In no event will Eaton be responsible to the purchaser or user in contract, in tort (including negligence), strict liability or other-wise forany special, indirect, incidental or consequential damage or loss whatsoever, including but not limited to damage or loss of use ofequipment, plant or power system, cost of capital, loss of power, additional expenses in the use of existing power facilities , or claimsagainst the purchaser or user by its customers resulting from the use of the information, recommendations and descriptions containedherein. The information contained in this manual is subject to change without notice.The i-on application includes the mbed TLS library, developed by a third party and licensed under the Apache 2.0 license. The Apache2.0 license can be found at: http://www.apache.org/licenses/LICENSE-2.0Guardall is a registered trademark of Guardall Limited.About this GuideThis guide is for people who need to install and configure an i-on10 intrusion system. Theguide gives an introduction to i-on10, provides pre-installation information, and explainshow to configure the unit using the options in the Installer menu of the user interface.Detailed installation information is given in the separate i-on10 Installation Instructions.Other PublicationsThe following additional publications are available: i-on10 User Guide – This provides an overview of the i-on10 intrusion system,including system components, key features and typical day-to-day tasks for endusers. i-on Series Administration and User Manual – This provides detailed informationabout how to set and unset the system, manage alarms and use the User menuoptions. Installation Instructions – Included in the packaging of each hardware device(such as a control unit or detector) are concise installation instructions that explainhow to install that device.