Eaton Scantronic i-on10 Configuration Manual

Also see for Scantronic i-on10: Installation instructions

System Options MenuPage 57Note: If you are using Fast Format communications, please ensure that one channel isallocated for tamper. If you do not do this, the control unit reports tamper as anunconfirmed Burg to ensure the condition is notified.Abort TimeUse this option to change Alarm Abort Delay period. The timer can take any value in therange 0 to 120 seconds.The control unit starts the Alarm Abort Delay timer whenever it starts an alarm. If a usersilences an alarm within the Abort Delay period, the alarm will not require an installer orremote reset.If an alarm occurs and a user unsets the system within the Alarm Abort Delay period, thecontrol unit activates any output of type Alarm Abort (page 38) and starts any Alarm AbortFast Format communications programmed.Auto RearmThis option is available when Confirmation Mode is set to Basic.Use this option to specify the number of times that the system will re-arm when the sirentime expires.Select NEVER to make the system never re-arm (the system will go into alarm once only).Select one of the other options to make the system re-arm once, twice, three, four or fivetimes, or always. The system re-arms all closed zones, but not detectors that are stillsending alarm signals. (Note that this setting is required in order to comply with EN50131.)If the system has rearmed, then when a user enters the system through the Final Exitdoor, the control unit will give an audible internal alarm in place of the normal entry tone.HardwarePanel NameYou can use this option to give the control unit a name. The name is displayed only whenusing the About, Panel option (page 65).Wired Zone TypeThe control unit prompts you to select the zone wiring type when you power up a controlunit for the first time, or when you restore the control unit to factory defaults (see page 51).Panel ZonesThis option lets you change the zone wiring type for the control unit.Please refer to page 14 for details of the wiring types.Panel LoudspeakerVolumeUse this option to change the volume of chime, entry, exit, alert, confirmation andother tones from a loudspeaker connected to the control unit. This volume controldoes NOT change the volume of alarm tones. You can separately adjust the volumeof each type of tone.