Eaton Scantronic i-on10 Configuration Manual

Also see for Scantronic i-on10: Installation instructions

Page 61Chapter 9: Test MenuSirens and SoundersThis option allows you to test the warning devices.Press  to turn the device on. Press  to turn the device off. The display shows Onwhen the device should be operating and Off when the device should be silent.Wired SirensThis option allows you to operate all outputs of type Siren and Strobe.LoudspeakersYou can use this option to test the sound from loudspeakers and keypads connected tothe system.Wired KeypadsUse this option to test the sounders on the wired keypads.KEY-RKPZTests the sounders in KEY-RKPZ two-way radio keypads.Wired KeypadUse this menu option to test the keypad you are currently using.When you start the test, the bottom line of the display shows the keypad name and busaddress. All four ABCD LEDs should glow. The LEDs around the navigation should allglow red. Every time you press a navigation key, the LEDs change colour. Press all thekeys one by one. The display should show you the key you pressed.To test the HUA keys, press them both at the same time. Note: An HUA alarm is notgenerated.Press  to leave the test.Radio KeypadsKEY-RKPZUse this menu option to test the KEY_RKPZ keypad you are currently using.This test behaves the same as for a wired keypad.Walk TestThe walk test menu provides several different ways of organising a walk test.When you select a Walk Test option (apart from Chime), the display shows the first item ina list of the detectors available for test. Walk around the area you wish to test and triggereach detector. If Chime is set to “On”, every time you trigger a detector, keypads and