Eaton Scantronic i-on10 Configuration Manual

Also see for Scantronic i-on10: Installation instructions

Test MenuPage 62loudspeakers give confirmation tone. The bottom-right corner of the display shows an “A” ifyou trigger the Alarm input and a “T” if you trigger the Tamper.The top of the display shows the number of zones left to test. The control unit decreasesthe number of zones every time you trigger an individual Alarm input.The bottom line of the display shows the zone name. To see the zone number press  or.Press  to end the test.Note: You can use Walk Test to test wired HUA switches. While you are using the Installermenu, activating a wired HUA switch will not cause an HUA alarm.If you wish to see which zones have not yet been tested, press the menu key. The bottomline of the display will show the first in a list of those zones remaining to test. As you testeach zone, it will disappear from the display. Press the menu key again to return to the fulllist of zones.If at least one zone is tested successfully, the log records a "Walk Test Complete" event,which shows the number of zones tested against the total number of zones system-wide.ChimeUse this option to select Once, On or Off. Once causes keypads and loudspeakers tochime only once for each zone that is triggered during the walk test. On generates achime every time a zone is triggered. Off switches off chiming.SystemThis option allows you to walk round the entire system and test all the zones.ZonesThis option lets you select one or more individual zones, and test only those zonesand no others.Use  or  to scroll up and down the list of zones. Press  or  to display “Yes” atthe end of the bottom line to mark the zone as one you want to test.Zone ResistancesWhen you select Zone Resistance, the display shows the first of the available wireddetectors. Press  or  to see the other detectors in the list.The bottom line of the display shows the zone name. To see the zone number press  or.The end of the bottom line shows the resistance of the zone. For 4-wire CC zones, thedisplay alternates between the Alarm resistance (“A”) and the Tamper resistance (“T”).“O/C” means Open Circuit.“0k00” means zero resistance or closed circuit.Zone StatusWired ZonesYou can use this option to display the current status of each zone. Select the zone youwant to check. The zone status (OK, alarm or tamper) is shown in the bottom-right cornerof the display.