Eaton Scantronic i-on10 Configuration Manual

Also see for Scantronic i-on10: Installation instructions

Detectors/Devices MenuPage 33 Either: Press  to return to the Installer menu to check that all keypads arelisted and addressed correctly. Make sure that the keypads are powered up. OR: Press  to make the control unit update its internal record of keypadsattached to the bus. The display shows:Press  to accept the changes, or press  to return without making changes.Note: Accepting changes deletes all programmed information for any lostkeypads.If you are re-scanning the bus through Address Bus Device, the display shows:If there are new keypads, continue as described in the previous section.Alternatively, press  if there are no new keypads.Changes are not saved until you leave Installer menu. If the control unit losespower before leaving Installer menu, the bus re-configure does not take effect.Wired KeypadsAddress Bus DeviceYou can use this option to add a wired keypad to the system once it is physically wired tothe bus. This is an alternative to using Detectors/Devices – Address Bus Device. Forfurther information, please refer to page 31.Edit KeypadYou can use this option to edit settings for a specific keypad.Note: If you wish to find out where the device is located, press “*”. The displayed devicewill sound a continuous tone. Press “#” to stop the tone.NameYou can give each keypad a name. The control unit displays the name when it is reportingfaults or other events, making it easier to locate the affected device.Key A/B/C/DThese options allow you to program the A, B, C and D (quick-set) keys. You can enablethe quick-set keys to full set the system, or set part sets B, C and D. To choose the settingmethod, select Action, Set, and then the required option. Each keypad can have a differentarrangement of quick-set keys.Each quick-set key can have a name. The keypad displays this name while the system issetting after the user presses that key.Note: The ABCD LEDs at the keypad show the state of the quick-set keys. When the partset that a quick-set key is allocated to is set, the associated LED glows. If you enable the quick-set keys, the control unit no longer complies with EN50131.See page 48.