Eaton Scantronic i-on10 Configuration Manual

Also see for Scantronic i-on10: Installation instructions

Page 69Appendix B: Installer Menu MapImportant: The defaults listed below enable the control unit to comply with EN50131requirements. If you change those settings, the installation may no longer comply. If thecontrol unit does not comply with EN50131, you must remove any labelling that indicatescompliance.Some options are available only if the relevant hardware is fitted, or for certain models ofcontrol unit.MENU Option Factory Default Notes1 Detectors/DevicesDetectors Program Zones Zone 0...Name “Zone n”Type Not usedAttributes All "off" Available when zone is given a typeother than “Not Used”.Some attributes are only available onparticular zone types.Double Knock does not comply withEN51031.Address BusDeviceWiredKeypadsAddress Bus DeviceEdit Keypad Keypad Kn-51...Name “Keypad Kn-nn”.Key A Name: “Key A”Action: Full SetKey B Name: “Key B”Action: Part Set BKey C Name: “Key C”Action: Part Set CKey D Name: “Key D”Action: Part Set DLoudspeakerVolumeAvailable only when a suitable keypadis fitted.Buzzer VolumeBacklightInternal Prox EnabledExternal Prox DisabledDelete KeypadEnable Keypad Yes (all keypads enabled)Replace KeypadRadioKeypadsKEY-RKPZAddress Bus DeviceEdit Keypad Keypad Kn-51...Name “Keypad Kn-nn”.Key A Name: “Key A”Action: Full SetKey B Name: “Key B”Action: Part Set BKey C Name: “Key C”Action: Part Set CKey D Name: “Key D”Action: Part Set DInternal Prox Enabled