IP Services Commands 131Nortel WLAN—Security Switch 2300 Series Command Line ReferenceUsage The maximum number of Telnet sessions supported on a WSS is eight. If SSH is alsoenabled, the switch can have up to eight Telnet or SSH sessions, in any combination, and oneconsole session.Examples The following command enables the Telnet server on a WSS:WSS# set ip telnet server enablesuccess: change accepted.See Also• clear ip telnet on page 102• set ip https server on page 116• set ip telnet on page 120• show ip https on page 152• show ip telnet on page 155set ntpEnables or disables the NTP client on a WSS.Syntax set ntp {enable | disable}Defaults The NTP client is disabled by default.Access Enabled.Usage If NTP is configured on a system whose current time differs from the NTP server time bymore than 10 minutes, convergence of the WSS time can take many NTP update intervals. Nortelrecommends that you set the time manually to the NTP server time before enabling NTP to avoid asignificant delay in convergence.Examples The following command enables the NTP client:WSS# set ntp enablesuccess: NTP Client enabledSee Also• clear ntp server on page 102• clear ntp update-interval on page 103• set ntp server on page 122• set ntp update-interval on page 122• show ntp on page 156enable Enables the NTP client.disable Disables the NTP client.
