VLAN Commands 95Nortel WLAN—Security Switch 2300 Series Command Line ReferenceUsage The output displays roaming stations within the previous 1 second.Examples To display all stations roaming to the WSS, type the following command:WSS# show roaming stationUser Name Station Address VLAN State---------------------- ----------------- --------------- -----redsqa 10.10.10.5 violet UpTable 12 describes the fields in the display.See Also show roaming vlan on page 85show roaming vlanShows all VLANs in the mobility domain, the WSSs servicing the VLANs, and their tunnel affinity values configuredon each switch for the VLANs.Table 2: Output for show roaming stationField DescriptionUser Name Name of the user. This is the name used for authentication. The name resides in aRADIUS server database or the local user database on a WSS.Station Address IP address of the user device.VLAN Name of the VLAN to which the RADIUS server or WSS local user databaseassigned the user.State State of the session:• Setup—Station is attempting to roam to this WSS. This switchhas asked the WSS from which the station is roaming for thestation’s session information and is waiting for a reply.• Up—WSS Software has established a tunnel between theWSSs and the station has successfully roamed to this WSS overthe tunnel.• Chck—This WSS is in the process of accepting a reassociationrequest from the roaming peer WSS for a station currentlyroaming to the peer switch.• TChck—This WSS is in the process of accepting areassociation request from the roaming peer WSS for a stationcurrently roaming to this switch.• WInd—This WSS is waiting for network congestion to clearbefore sending the roaming indication to the roaming peerWSS.• WResp—This WSS is waiting for network congestion to clearbefore sending the roaming response to the roaming peer WSS.
