521Nortel WLAN—Security Switch 2300 Series Command Line ReferenceRF Detection CommandsWSS Software automatically performs RF detection scans on enabled and disabled radios to detect rogueaccess points. A rogue access point is a BSSID (MAC address associated with an SSID) that does not belongto a Nortel device and is not a member of the ignore list configured on the seed switch of the Mobility Domain.WSS Software can issue countermeasures against rogue devices to prevent clients from being able to usethem.You can configure RF detection parameters on individual WSSs.This chapter presents RF detection commands alphabetically. Use the following table to locate the commandsin this chapter based on their use.Rogue Information show rfdetect clients on page 520show rfdetect mobility-domain on page 526show rfdetect data on page 524show rfdetect visible on page 531show rfdetect counters on page 523Countermeasures show rfdetect countermeasures on page 522Permitted Vendor List set rfdetect vendor-list on page 518show rfdetect vendor-list on page 531clear rfdetect vendor-list on page 514Permitted SSID List set rfdetect ssid-list on page 517show rfdetect ssid-list on page 530clear rfdetect ssid-list on page 513Client Black List set rfdetect black-list on page 515show rfdetect black-list on page 519clear rfdetect black-list on page 512Attack List set rfdetect attack-list on page 514show rfdetect attack-list on page 519clear rfdetect attack-list on page 512Ignore List set rfdetect ignore on page 515show rfdetect ignore on page 526clear rfdetect ignore on page 513AP Signatures set rfdetect signature on page 517Log Messages set rfdetect log on page 516WSS-to-Client RF Link rfping on page 533
