410 STP CommandsNN47250-100 (Version 02.51)Defaults Disabled.Access Enabled.Usage The uplink fast convergence feature is applicable to bridges that are acting as access switches to thenetwork core (distribution layer) but are not in the core themselves. Do not enable the feature on WSSs that arein the network core.Examples The following command enables uplink fast convergence:WSS# set spantree uplinkfast enablesuccess: change accepted.See Also show spantree uplinkfast on page 412show spantreeDisplays STP configuration and port-state information.Syntax show spantree [port port-list | vlan vlan-id] [active]Defaults None.Access All.HistoryExamples The following command displays STP information for VLAN default:WSS# show spantree vlan defaultVLAN 1Spanning Tree Mode PVST+Spanning Tree Type IEEESpanning Tree EnabledDesignated Root 00-02-4a-70-49-f7Designated Root Priority 32768Designated Root Path Cost 19Designated Root Port 1Root Max Age 20 sec Hello Time 2 sec Forward Delay 15 secBridge ID MAC ADDR 00-0b-0e-02-76-f7Bridge ID Priority 32768port port-list List of ports. If you do not specify any ports, WSS Software displays STPinformation for all ports.vlan vlan-id VLAN name or number. If you do not specify a VLAN, WSS Softwaredisplays STP information for all VLANs.active Displays information for only the active (forwarding) ports.Version 4.1 Value STP Off added for STP-State and Port-State fields. Thisstate indicates that STP is disabled on the port. The Disabledstate is still used, but only to indicate that the port is notforwarding traffic.
