AP Commands 381Nortel WLAN—Security Switch 2300 Series Command Line Referenceshow ap connectionDisplays the system IP address of the WSS that booted a AP.Syntax show ap connection [ap-num | serial-id serial-ID]Defaults None.Access Enabled.Usage The serial-id parameter displays the active connection for the specified AP even if that AP is notconfigured on this WSS. If you instead use the command with the ap-num parameter or without a parameter,connection information is displayed only for APs that are configured on this WSS.This command provides information only if the AP is configured on the switch where you use the command.The switch does not need to be the one that booted the AP, but it must have the AP in its configuration. Also,the switch that booted the AP must be in the same Mobility Domain as the switch where you use thecommand.Switch Whether the AP is configured to use a manually specified WSSas its boot device.Mesh Whether WLAN mesh services are enabled for thisAP.IP address The static IP address assigned to this AP.Netmask The subnet mask assigned to this AP.Gateway The IP address of the default gateway assigned to this AP.Switch IP The IP address of the WSS that this AP is configured to use as itsboot device (if any).Switch Name The name of the WSS that this AP is configured to use as its bootdevice (if any).DNS IP The IP address of the DNS server that the AP uses to resolve thename of the WSS used as its boot device.Mesh SSID The WLAN mesh services SSID this AP is configured to use (ifany).Mesh PSK The preshared key (PSK) the AP uses for authentication with aMesh Portal AP (if any).)ap-num Number of a AP for which to display information about its activeconnection.serial-id serial-ID AP serial ID.Table 18: Output for show ap boot-configuration (continued)Field Description
