494 RADIUS and Server Groups CommandsNN47250-100 (Version 02.51)Defaults Global RADIUS parameters have the following default values:• deadtime—0 (zero) minutes (The WSS does not designate unresponsive RADIUS servers as unavailable.)• key—No key• retransmit—3 (the total number of attempts, including the first attempt)• timeout—5 secondsAccess Enabled.History Introduced in WSS Software 1.0.Usage To override the globally set values on a particular RADIUS server, use the set radius servercommand.Examples To reset all global RADIUS parameters to their factory defaults, type the following commands:WSS# clear radius deadtimesuccess: change accepted.WSS# clear radius keysuccess: change accepted.WSS# clear radius retransmitsuccess: change accepted.WSS# clear radius timeoutsuccess: change accepted.See Also• set radius on page 487• set radius server on page 490• show aaa on page 210clear radius client system-ipRemoves the WSS’s system IP address from use as the permanent source address in RADIUS client requests from theswitch to its RADIUS server(s).Syntax clear radius client system-ipDefaults None.Access Enabled.History Introduced in WSS Software 1.0.Usage The clear radius client system-ip command causes the WSS to use the IP address of the interfacethrough which it sends a RADIUS client request as the source IP address. The WSS selects a source interfaceaddress based on information in its routing table as the source address for RADIUS packets leaving the switch.retransmit Number of transmission attempts made before declaring an unresponsiveRADIUS server unavailable.timeout Number of seconds to wait for the RADIUS server to respond beforeretransmitting.
