AP Commands 383Nortel WLAN—Security Switch 2300 Series Command Line Referenceshow ap globalDisplays connection information for APs configured on a WSS.Syntax show ap global [ap-num | serial-id serial-ID]Defaults None.Access Enabled.Usage Connections are shown only for the APs that are configured on the WSS from which you enter thecommand, and only for the Mobility Domain the switch is in.To show information only for APs that have active connections, use the show ap connection command.Examples The following command displays connection information for all the APs configured on a WSS:WSS# show ap globalTotal number of entries: 8AP Serial Id WSS IP Address Bias--- ----------- ---------------------- ----1 11223344 10.3.8.111 HIGH- 11223344 10.4.3.2 LOW2 332211 10.3.8.111 LOW- 332211 10.4.3.2 HIGH17 0322100185 10.3.8.111 HIGH- 0322100185 10.4.3.2 LOW18 0321500120 10.3.8.111 LOW- 0321500120 10.4.3.2 HIGHTable 53 describes the fields in this display.ap-num Number of a AP for which to display configuration settings.serial-id serial-ID AP serial ID.Table 20: Output for show ap globalField DescriptionAP Connection ID you assigned to the AP.Note: AP numbers are listed only for APs configured on thisWSS. If the field contains a hyphen ( - ), the AP configurationdisplayed in the row of output is on another WSS.Serial Id Serial ID of the AP.
