50 Port CommandsNN47250-100 (Version 02.51)Defaults PoE is disabled on network and wired authentication ports. The state on AP portsdepends on whether you enabled or disabled PoE when setting the port type. See set port type ap onpage 41.Access Enabled.Usage This command does not apply to any gigabit Ethernet ports or to ports 7 and 8 on the 2360and 2382 switch.Examples The following command disables PoE on ports 7 and 9, which are connected to an AP:WSS# set port poe 7,9 disableIf you are enabling power on these ports, they must be connected only to approved PoEdevices with the correct wiring. Do you wish to continue? (y/n) [n]yThe following command enables PoE on ports 7 and 9:WSS# set port poe 7,9 enableIf you are enabling power on these ports, they must be connected only to approved PoEdevices with the correct wiring. Do you wish to continue? (y/n) [n]ySee Also• set port type ap on page 41• set port type wired-auth on page 44set port speedChanges the speed of a port.Syntax set port speed port-list {10 | 100 | 1000 | auto}Defaults All ports are set to auto.Access Enabled.Usage Nortel recommends that you do not configure the mode of a WSS port so that one side ofthe link is set to autonegotiation while the other side is set to full-duplex. Although WSS Softwareallows this configuration, it can result in slow throughput on the link. The slow throughput occursbecause the side that is configured for autonegotiation falls back to half-duplex. A stream of largeport-list List of physical ports. WSS Software sets the port speed on all thespecified ports.10 Sets the port speed of a 10/100 Ethernet port to 10 Mbps and sets theoperating mode to full-duplex.100 Sets the port speed of a 10/100 Ethernet port to 100 Mbps and sets theoperating mode to full-duplex.1000 Sets the port speed of a gigabit Ethernet port to 1000 Mbps and sets theoperating mode to full-duplex.auto Enables a port to detect the speed and operating mode of the traffic on thelink and set itself accordingly.
