243Nortel WLAN—Security Switch 2300 Series Command Line ReferenceAP CommandsUse AP commands to configure and manage APs. Be sure to do the following before using the commands:• Define the country-specific IEEE 802.11 regulations on the WSS. (See set system countrycode onpage 63.)• Install the AP and connect it to a port on the WSS. (See the Nortel Access Point 2330/2330A/2330BInstallation Guide or Nortel Series 2332 Access Point Installation Guide.)• Configure an AP access port (for a directly connected AP) or a AP. (See set port type ap on page 41 andset ap on page 33.)This chapter presents AP commands alphabetically. Use the following table to locate commands in thischapter based on their use.Caution! Changing the system country code after AP configuration disables APs anddeletes their configuration. If you change the country code on a WSS, you mustreconfigure all APs.Note. For Series 2332 access points, be sure the system country code is supported forthe selected access point model.Automatic Configuration ofAPsset ap auto on page 245set ap auto mode on page 247set ap auto radiotype on page 248set ap auto persistent on page 247set ap bias on page 249set ap blink on page 250set ap group on page 258set ap radio auto-tune max-power on page 265set ap radio auto-tune max-retransmissions on page 266set ap radio mode on page 270set ap radio radio-profile on page 271set ap auto radiotype on page 248set ap upgrade-firmware on page 275External Antennas set ap radio antennatype on page 263set ap radio antenna-location on page 262
