802.1X Management Commands 507Nortel WLAN—Security Switch 2300 Series Command Line Referenceclear dot1x port-controlResets all wired authentication ports on the WSS to default 802.1X authentication.Syntax clear dot1x port-controlDefaults By default, all wired authentication ports are set to auto and they process authentication requestsas determined by the set authentication dot1X command.Access Enabled.History Introduced in WSS Software 1.0.Usage This command is overridden by the set dot1x authcontrol command. The clear dot1x port-controlcommand returns port control to the method configured. This command applies only to wired authenticationports.Examples Type the following command to reset the wired authentication port control:WSS# clear dot1x port-controlsuccess: change accepted.See Also• set dot1x port-control on page 502• show dot1x on page 507clear dot1x quiet-periodResets the quiet period after a failed authentication to the default setting.Syntax clear dot1x quiet-periodDefaults The default is 60 seconds.Access Enabled.History Introduced in WSS Software 1.0.Examples Type the following command to reset the 802.1X quiet period to the default:WSS# clear dot1x quiet-periodsuccess: change accepted.See Also• set dot1x quiet-period on page 503• show dot1x on page 507clear dot1x reauth-maxResets the maximum number of reauthorization attempts to the default setting.Syntax clear dot1x reauth-maxDefaults The default is 2 attempts.
