510 802.1X Management CommandsNN47250-100 (Version 02.51)set dot1x authcontrolProvides a global override mechanism for 802.1X authentication configuration on wired authentication ports.Syntax set dot1x authcontrol {enable | disable}Defaults By default, authentication control for individual wired authentication is enabled.Access Enabled.History Introduced in WSS Software 1.0.Usage This command applies only to wired authentication ports.Examples To enable per-port 802.1X authentication on wired authentication ports, type the followingcommand:WSS# set dot1x authcontrol enablesuccess: dot1x authcontrol enabled.See Also• set dot1x port-control on page 502• show dot1x on page 507set dot1x bonded-periodChanges the Bonded Auth™ (bonded authentication) period. The Bonded Auth period is the number of seconds WSSSoftware allows a Bonded Auth user to reauthenticate.Syntax set dot1x bonded-period secondsDefaults The default bonded period is 0 seconds, which disables the feature.Access Enabled.History Introduced in WSS Software 2.1.Usage Normally, the Bonded Auth period needs to be set only if the network has Bonded Auth clients thatuse dynamic WEP, or use WEP-40 or WEP-104 encryption with WPA or RSN. These clients can be affectedby the 802.1X reauthentication parameter or the RADIUS Session-Timeout parameter.enable Allows all wired authentication ports running 802.1X to use theauthentication specified per port by the set dot1X port-controlcommand.disable Forces all wired authentication ports running 802.1X to unconditionallyaccept all 802.1X authentication attempts with an EAP Success message(ForceAuth).seconds Number of seconds WSS Software retains session information for anauthenticated machine while waiting for a client to (re)authenticate on thesame machine. You can change the bonded authentication period to avalue from 1 to 300 seconds.
