276 AP CommandsNN47250-100 (Version 02.51)Syntax set {ap port-list | auto}} radio {1 | 2} auto-tune max-power power-levelDefaults The default maximum power setting that RF Auto-Tuning can set on a radio is the highest settingallowed for the country of operation or highest setting supported on the hardware, whichever is lower.Access Enabled.HistoryExamples The following command sets the maximum power that RF Auto-Tuning can set on radio 1 on theAP on port 7 to 12 dBm.WSS# set ap 7 radio 1 auto-tune max-power 12success: change accepted.See Also• set radio-profile auto-tune power-config on page 282• set radio-profile auto-tune power-interval on page 283set ap radio auto-tune max-retransmissionsDeprecated in WSS Software Version 5.0.set ap radio auto-tune min-client-rateDeprecated in WSS Software Version 5.0. To configure radio transmit rates, See set service-profile transmit-rates onpage 334.ap port-list List of ports connected to the AP on which to set themaximum power.ap ap-num Number of a AP on which to set the maximum power.ap auto Sets the maximum power for radios configured by the APconfiguration profile. (See set ap auto on page 245.)radio 1 Radio 1 of the AP.radio 2 Radio 2 of the AP. (This option does not apply to single-radiomodels.)power-level Maximum power setting RF Auto-Tuning can assign to theradio, expressed as the number of decibels in relation to 1milliwatt (dBm). You can specify a value from 1 up to themaximum value allowed for the country of operation.The power-level can be a value from 1 to 20.Version 4.0 Option auto added for configuration of the AP configurationprofile.Version 6.0 Option dap removed.
