278 AP CommandsNN47250-100 (Version 02.51)set ap radio min-tx-datarateTo specify the minimum rate at which a radio is allowed to transmit traffic to clients, see Deprecated in WSSSoftware Version 5.0. on page 266.set ap radio link-calibrationConfigures an AP radio to emit link calibration packets, which can aid in positioning a Mesh AP.Syntax set ap ap-number radio {1 | 2} link-calibration mode {enable | disable}Defaults Disabled.Access Enabled.History Introduced in WSS Software Version 6.0.Usage A Mesh Portal AP can be configured to emit link calibration packets to assist withpositioning the Mesh AP. A link calibration packet is an unencrypted 802.11 management packet oftype Action. When enabled on an AP, link calibration packets are sent at a rate of 5 per second.Only one radio on an AP can be configured to send link calibration packets. Link calibration packetsare intended to be used only during installation of APs; they are not intended to be enabled on acontinual basis.Examples The following command enables link calibration packets for AP radio 1 on AP 7:WSS# set ap 7 radio 1 link-calibration mode enablesuccess : anchor calibration enabled on AP 7 on radio 1.See Also• set ap boot-configuration mesh ssid on page 254• set service-profile mesh on page 320• show ap mesh-links on page 357set ap radio load-balancingDisables or enables RF load balancing for an AP radio.ap ap-number Index value that identifies the AP on the WSS.radio 1 Radio 1 of the AP.radio 2 Radio 2 of the AP. (This option does not apply to single-radio models.)enable Enables link calibration packets for the AP radio.disable Disables link calibration packets for the AP radio.
