IGMP Snooping Commands 429Nortel WLAN—Security Switch 2300 Series Command Line ReferenceSyntax set igmp oqi seconds [vlan vlan-id]Defaults The default other-querier-present interval is 255 seconds (4.25 minutes).Access Enabled.Usage A WSS cannot become the querier unless the pseudo-querier feature is enabled on the switch. Whenthe feature is enabled, the switch becomes the querier for a subnet so long as the switch does not receive aquery message from a router with a lower IP address than the IP address of the switch in that subnet. To enablethe pseudo-querier feature, use set igmp querier.Examples The following command changes the other-querier-present interval on VLAN orange to 200seconds:WSS# set igmp oqi 200 vlan orangesuccess: change accepted.See Also• set igmp lmqi on page 416• set igmp qi on page 420• set igmp qri on page 420• set igmp querier on page 421• set igmp mrouter on page 417• set igmp rv on page 422set igmp proxy-reportDisables or reenables proxy reporting by a WSS on one VLAN or all VLANs.Syntax set igmp proxy-report {enable | disable} [vlan vlan-id]Defaults Proxy reporting is enabled on all VLANs by default.Access Enabled.oqi seconds Number of seconds that the WSS waits for a general query to arrivebefore electing itself the querier. You can specify a value from 1 through65,535.vlan vlan-id VLAN name or number. If you do not specify a VLAN, the timer changeapplies to all VLANs.enable Enables proxy reporting.disable Disables proxy reporting.vlan vlan-id VLAN name or number. If you do not specify a VLAN, proxy reporting isdisabled or reenabled on all VLANs.
