Network Domain Commands 237Nortel WLAN—Security Switch 2300 Series Command Line ReferenceDefaults None.Access Enabled.History Introduced in WSS Software 4.1.Usage This command has no effect if the WSS is not configured as a Network Domain seed.Examples The following command clears the Network Domain peer configuration for peer 192.168.9.254from the WSS:23x0# clear network-domain peer 192.168.9.254success: change accepted.The following command clears the Network Domain peer configuration for all peers from the WSS:23x0# clear network-domain peer allsuccess: change accepted.See Also set network-domain peer on page 228clear network-domain seed-ipRemoves the specified Network Domain seed from the WSS’s configuration. When you enter this command, theNetwork Domain TCP connections between the WSS and the specified Network Domain seed are closed.Syntax clear network-domain seed-ip ip-addrDefaults None.Access Enabled.History Introduced in WSS Software 4.1.Usage This command has no effect if the WSS is not configured as part of a Network Domain, or if theWSS is not configured as a member of a Network Domain that uses the specified Network Domain seed.Examples The following command removes the Network Domain seed with IP address 192.168.9.254 fromthe WSS’s configuration:23x0# clear network-domain seed-ip 192.168.9.254success: change accepted.See Also set network-domain mode member seed-ip on page 227set network-domain mode member seed-ipSets the IP address of a Network Domain seed. This command is used for configuring a WSS as a member of a NetworkDomain. You can specify multiple Network Domain seeds and configure one as the primary seed.ip-addr IP address of the Network Domain seed in dotted decimal notation.
